Design Concept

The original Creality waste bin is a bit too big for my setup. I found a smaller bin and really liked the simplicity of it but found that I had to empty it too often. So, I remixed the model to act as a chute or slide so that the poop can 'slide' off into a larger bin next to my desk.

Changes

It's a longer print than the original.

I made the following changes:

Opened the bin on the one side and placed an angled plane or slide for the poop to run off.

Filled the rest of the hollow bin and made space for some of the Creality Hi tools.

Shortened the blocker by 5mm.

Printing Recommendations

There are two files - you will need both the slide and the blocker.

You can print with PLA or PETG - I recommend the latter.

The uploaded print setting already contains these recommendations:

0.20mm Layer Height

10% - 15% Rectilinear Infill

Tree supports required (Removed in 5mins. I used a screwdriver to break it free inside the glue stick compartment)

You need to enable 'slow down for overhangs' (Usually on by default)

Assembly Instructions

Slide the model down from the frame into place. Clip the blocker into place as shown in my images, above.

My thanks to the @Ricc here on Creality Cloud for the smaller waste bin and great design. See the link at the bottom of this page to view that model - It is worth the print. I will be using both depending on how my setup changes.

If you find this remix useful in any way - Please leave a LIKE!!

Creality Hi Poop Slide

0.2mm layer, 2 walls, 10% infill

0.2mm layer, 2 walls, 15% infill

0.2mm layer, 2 walls, 15% infill